Home

Products

Omni Stick

Contact

Purchase

WORKS GREAT ON:

Wood

Metal

Fiberglass

Glass

Concrete

Ceramics

China

Porcelain

Marble

Metal

Rubber

Most Plastics

Directions:

EASY-TO-USE DISPENSER

  1. 1. Hold dispenser, with nozzle end up. Pull back plunger slightly (1/8”) to allow air bubbles to rise to the top.

  2. 2. Cut each nozzle at the top with scissors or a knife.

  3. 3. Push down on plunger to dispense equal amounts of resin and hardener onto a clean, disposable surface. Pull back plunger to stop flow. MIX THOROUGHLY.

  4. 4. Apply to both surfaces to be bonded. Hold together with a clamp, tape or weights. Sets in 5 Minutes; full strength in 12 to 24 hours.

  5. 5. To reseal: remove storage cap between syringes, wipe off each tip and snap on cap (fits one way only). Store in upright position.

Area to be repaired must be clean and dry. For best results, roughen surfaces before applying epoxy. Application temperature should be 60ºF (15ºC) or above. NOTE: This product not recommended for use above 200ºF (93ºC)

SET IN 5 MINUTES! CURES IN 24 HOURS!

Welcome_To_Hammerhead_America.html

Epoxy Cement